Secabo C40 Instruções de Operação descarregar pdf (Página 17)

1mm“ so that the cut elements do not receive a white border later on. While

calibrating it is best to use the value “0 mm“. Please confirm your entry by

clicking the green check mark on the bottom right in the menu.

• Now choose the menu “Effects“ – “Contour cutting mark“.

• Now you can choose whether two cutting marks horizontally or vertically shall

be set. With small prints two marks are enough as they can be read in faster.

With larger printed sheets 4 marks should be used to reach a higher

accuracy. Please confirm your entry by clicking the green check mark on the

bottom right of the menu.

Attention! After the setting of the marks the object cannot be scaled

Attention! After the setting of the marks the object cannot be scaled Attention! After the setting of the marks the object cannot be scaled

Attention! After the setting of the marks the object cannot be scaled

anymore!

anymore!anymore!

anymore!

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Sem comentários

Secabo C40 Instruções de Operação Página 17