Secabo C40 Especificações descarregar pdf (Página 7)

5. Device Settings

5.1. Changing the cutting force and speed

If the cutting plotter is plotting, you need to press the Local key to stop the plotter. Pressing the

Local key again will restart the plot.

To change the cutting force, turn the small wheel inside the cutting plotter on the right. The force can be

set in 8 steps, where the lowest setting corresponds to 70g and the highest to 350g.

Recommended values for several media:

normal self-adhesive media: approx. 100g

Transflex media: approx. 100g

Neon foil: approx. 110g

Flock foil: approx. 120g

Laminated media: approx. 180g-250g,

Sandblast foil: approx. 300g-400g

When setting the cutting force, please note that the correct setting mainly depends on the knife

holder, the position of the knife, and the loaded media. These settings are subject to variation.

To set the cutting speed, press the Speed key multiple times. The LEDs illuminate to indicate the set

speed. There are 6 speed settings: Speed 1-3 – green LEDs lit, Speed 4-6 – a red LED illuminates additi-

onally.

For faster results, always set the speed to the maximum value: a slower speed only makes sen-

se for fine figures or tough materials.

5.2 Pausing a plot

o pause a plot, press the „Local“ key. Press the „Local“ key again to continue the job seamlessly where

you left off.

5.3 Repeating the last plot

To repeat a plot after plotting without needing to resend, simply press the „Copy“ on the cutting plotter.

The cutting plotter will now repeat the last plot.

1 2 3 4 5 6 7 8 9 10

Sem comentários

Secabo C40 Especificações Página 7